stern tube

Analysis on Force and Deformation of Ship Stern Tube Seal Ring

船舶尾轴橡胶密封环变形和受力的计算分析

Respectively lase both sides of the stern tube in order to measure the boring dimensions roughly.

在艉轴管前后分别用激光粗打镗孔余量的分布情况.

Inspection push-up load for fore and aft stern tube bushes.

艉轴管前、后衬套压入检查.

Introduced the opening and using of the stern tube system software.

介绍了船舶尾管系统软件的开发和使用。

Hydraulic test for L . O . pipe for stern tube.

艉轴管滑油液压试验.

The vibration amplitude of the new type of water-lubrication stern tube rubber bearing is obviously lower than plain NBR tail bearing.

通过橡胶轴承的振动试验可知，无论在低频、中频还是高频，新型水润滑橡胶尾轴承的振动都低于普通丁腈橡胶尾轴承。

Measuring diameter of fore and aft stern tube bearing and bushes.

艉轴管前、后轴承与衬套直径测量.

The feasible analysis on the closed type water-lubricated stern tube

闭式水润滑尾轴尾管装置可行性研究

With the minimum frictional power loss and the maximum "the minimum oil film thickness" as the optimum objectives, the marine stern tube bearing is optimized by adjusting the length to diameter ratio, the clearance ratio and the altitude angle ratio.

并分别以功耗最小、最小油膜厚度最大为优化目标，通过改变长径比、间隙比、偏角比对尾管轴承进行了优化设计。

Analyses of the load capacity of water lubricated stern tube bearing

水润滑艉轴承负载能力的分析

The analysis shows that the local fatigue life of the bearing plate of the rubber stern tube bearing may be decided by the local load.

分析表明，橡胶艉轴承承载板条的局部疲劳寿命与局部承受的载荷有很大关系，局部受力越大，该区域的疲劳寿命越低。

It constructed the math model of the ship shafting transverse vibration and the lubricative capability calculation of stern tube bearing.

分别构建了船舶轴系横向振动和船舶尾管轴承润滑性能计算的数学模型。